Flexible Parallel Bar for Physiotherapy Purposes
Abstract
The utilization of parallel bars in rehabilitative and active recuperations is crucially critical in the medicinal services calling. Parallel bars are utilized to enable individuals to recover their quality, adjust, scope of movement, and freedom. For individuals recouping from wounds, ailments, and other crippling conditions, parallel bars are importance things of active recuperation, recovery, and exercise hardware. However, there are some obstacles while adjusting the bar height according to patient’s height. This is because the height of bar is adjusted manually by a physiotherapist. It will take time before the patient’s allowed to use it. Therefore, Flexible Parallel Bar is designed to address this problem. This design consists of a control unit that will control bar on the left and right. Control panel comprises a selection switch (left and right) and up/down button. Forward reverse motor is used to downward and upward the shaft according to the desired height. In addition, the parallel bar design is portable. This allows the family member assemble the parallel bar at home. This can save time to commute from home to a physiotherapy center where as the physiotherapy exercises can be done at home or everywhere that request by patient.
Downloads
References
REFERENCES
Luis MochizukiI, Aline Bigongiari, Patricia Martins Franciulli, Juliana Valente Francica, Angelica Castilho Alonso, Ulysses Fernandes Ervilha, Henry Dan Kiyomoto and Julia Maria D’Andrea Greve, (2015) “The effect of gait training and exercise programs on gait and balance in post-stroke patients” Medical Express, vol. 2, no. 4, Pp. 1-5.
Sari Abdo Ali, Khalil Azha Mohd Annuar and Muhammad Fahmi Miskon, (2016) “Trajectory planning for exoskeleton robot by using cubic and quintic polynomial equation” International Journal of Applied Engineering Research, Volume 11, Issue 13, Pp. 7943-7946.
David J.Stott and Terence J.Quinn (2017) “Principles of rehabilitation of older people” Medicine, Volume 45, Issue 1, Pp. 1-5.
Dorta, H. S. (2015)”Physical Therapy in the Pre and Post the Transtibial Amputation”, International Journal of Physical Medicine & Rehabilitation, 03(03), pp. 1–3.
Audrey Vanhaudenhuyse, Aline Gillet, Nicole Malaise, Irène Salamun, StéphanieGrosdent, Didier Maquet, Anne-Sophie Nyssen, Marie-Elisabeth Faymonville “Psychological interventions influence patients' attitudes and beliefs about their chronic pain” Journal of Traditional and Complementary Medicine, Volume 8, Issue 2, Pp. 296-302.
Jesse Osborn, (2018) “The Effect of High-Intensity Interval Training on the Gait Speed and Balance of an Individual with Parkinson's Disease” Azusa Pacific University, ProQuest Dissertations Publishing, Pp. 1-71.
Thomas Edwards, Lara A. Piluttib (2017) “The effect of exercise training in adults with multiple sclerosis with severe mobility disability: A systematic review and future research directions”, Multiple Sclerosis and Related Disorders, Volume 16, Pp. 31-39.
Rebecca M. Henderson, X. Iris Leng, Elizabeth A. Chmelo, Tina E. Brinkley, Mary F. Lyles, Anthony P. Marsh, Barbara J. Nicklas (2017) “Gait speed response to aerobic versus resistance exercise training in older adults” Aging Clinical and Experimental Research, Volume 29, Issue 5, Pp. 969–976.
Clinton Industries Inc, (2013) “Physical Therapy Equipment” Clinton Industries Inc, Pp. 38-40.
Khalil Azha Mohd Annuar, Wan Norhisyam Abd Rashid, Mohd Razali Mohamad Sapiee, Nik Azran Ab Hadi, Mohd Syahril Mohd Azali, (2018) “PI Controller Design for DC Motor Using Different Power Electronic Converters” Journal of Telecommunication, Electronic and Computer Engineering (JTEC), Vol:10, No. 1-11, pp 119-123.
Ryan Helle,s, Justin Knowles, Jeffery Osborne, Jessica Stalker and Justin Vowles (2008) “Design and development of automated parallel bars” Multi-Disciplinary Engineering Design Conference, Project Number: 08002, Pp. 1-8
Downloads
Published
How to Cite
Issue
Section
License
The articles may be used for research, teaching, and private study purposes. Any substantial or systematic reproduction, redistribution, reselling, loan, sub-licensing, systematic supply, or distribution in any form to anyone is expressly forbidden. Authors alone are responsible for the contents of their articles. The journal owns the copyright of the articles. However, within the framework of Creative Commons (CC) copyright license, authors can use their published works in non-profit environments and share them on their own platforms on the internet. The publisher shall not be liable for any loss, actions, claims, proceedings, demand, or costs or damages whatsoever or howsoever caused arising directly or indirectly in connection with or arising out of the use of the research material. All authors are requested to disclose any actual or potential conflict of interest including any financial, personal or other relationships with other people or organizations regarding the submitted work.
The author (s) guarantees that the submitted article is his/her/their original research. All authors participating in this study assumed public responsibility and confirmed that the article was not submitted for another journal. All the articles in the article do not violate the existing copyright rules and intellectual property rights of any person or organization. The article meets the ethical standards applicable to the research discipline.
The authors cannot withdraw the article they have uploaded to IJHaTI journal and upload it to another journal without the approval of the journal editor.
Authors are responsible for obtaining written permission to include any images or artwork for which they do not hold copyright in their articles, or to adapt any such images or artwork for inclusion in their articles. The copyright
